MDF Rose Engine 2.0
3D Printing Parts
for the MDF Rose Engine Lathe 2.0
Curvilinear Slide

Click on any picture to see a larger version.
Templates
Template 01
G-code Curv_Tmplt-01.gcode 7" long   x   1/8" thick

Rubbed edge is chamfered top & bottom 0.05"

STL Curv_Tmplt-01.stl  
Rubbers
Rubber - Point
G-code Curv-Rubber-Pt.gcode Point nose
STL Curv-Rubber-Pt.stl

Rubber 0.75"
G-code Curv-Rubber-0.75.gcode 3/4" diameter nose
STL Curv-Rubber-0.75.stl

Rubber 1.5"
G-code Curv-Rubber-1.5.gcode 1 1/2" diameter nose
STL Curv-Rubber-1.5.stl
Limit Switch Parts
Limit Switch Base
G-code Curv-LimSwBase.gcode Use same design for left and right sides
STL Curv-LimSwBase.stl

Limit Switch Holder
G-code Curv-LimSwHolder.gcode Use same design for left and right sides

Holes will need to be drilled manually for the limit switch used, and its position

STL Curv-LimSwHolder.stl

Image to the right shows the McMaster-Carr p/n 7779K13 installed with wire terminators for use on the left side of the rubber arm. For the right side, flip the switch 180 degrees.

Check to ensure you use the correct terminals for Normally Open or Normally Closed, depending on your preference.